Volume 48, N. 2

April-June 2025

Influence of loading mode on the response of a helical pile subjected to cyclic tensile loads in sand

Abstract

Helical piles are steel elements consisting of one or more helices placed along a central shaft and installed in the ground through rotation. This study describes a field investigation of the behavior of a helical pile prototype subjected to cyclic tensile loads in a site composed of pure sand layers. During the investigation, the helical pile prototype featured three helices and was equipped with electrical resistance strain gauges at three different sections along the shaft. Two cyclic tensile load tests were conducted during the investigation using quasi-static (low-frequency) cyclic loadings. In each test, cyclic loads were applied in four distinct stages. The maximum load reached in each stage was the same in both load tests. However, the cyclic amplitude between stages increased in one load test and kept constant in the other. A static load test was performed immediately after unloading one of the cyclic tests to evaluate the influence of the cycles on the static load capacity. The results revealed that the helix closest to the pile tip contributed the most to the total axial load capacity. Proportionally, the tip helix had the highest contribution among all the helices from the beginning of the test. The mode of load increment application influenced the pile response. Increasing cyclic loads between stages led to an increase in the proportion of the load mobilized at the tip helix and a decrease in the proportion mobilized at the upper helices.

Keywords: Helical pile, Tensile load test, Cyclic loading, Aeolian sand,


Submitted on August 12, 2024.
Final Acceptance on May 06, 2025.
Discussion open until August 31, 2025.
DOI: 10.28927/sr.2025.006224