Mohr’s circle is a convenient geometric method to solve two-dimensional stress and strain problems in geotechnical engineering and materials engineering. The pole point is such a special point that can help readily find stresses and strains on any specified plane by using a diagram instead of complex computations. This paper first presents two conventional pole point methods of a Mohr’s strain circle, i.e., the parallel line method and the normal line method. A new method of determining the pole point of strain, called the ray method, is then proposed. It was found that the parallel line method and the normal line method are two special cases of the ray method; however, the parallel line method was proved the most efficient way to determine the strains for a specified plane. The uniqueness of the pole point was proved by using an indirect proof; and the pole point method was verified by a theoretical method. Results also show that Mohr’s strain and stress circles can be drawn in a concentric circle. Based on the relationship between the pole points of stress and strain, any relatively complex stress and strain states can be determined by using the pole point method rather than using the theoretical method.