Special Issue: Mining Frontiers - Knowledge, Innovation and Sustainability (Invited Editors: A. Kormann, C.E.R. Lautenschläger), October-December, in progress, 2026
This paper presents a field-based assessment of near-surface hydraulic conductivity in a compacted filtered iron ore tailings stack using mini-infiltrometer tests. A total of 115 in situ measurements were performed on the compacted surface, providing a dataset for evaluating the variability of near-surface field measurements under controlled suction conditions. The mini-infiltrometer results are interpreted as hydraulic conductivity values associated with the pressure head applied at the porous disk–tailings interface, not necessarily as fully saturated hydraulic conductivity. The measured values ranged from 1.14 × 10−7 m/s to 4.59 × 10−6 m/s, with an arithmetic mean of 1.31 × 10−6 m/s, a median of 1.20 × 10−6 m/s, and a geometric mean of 1.12 × 10−6 m/s. Although the results were concentrated around 10−6 m/s, the coefficient of variation was approximately 56.9%, indicating relevant relative variability. Most values were located between 5.0 × 10−7 m/s and 3.0 × 10−6 m/s, supporting the use of the geometric mean as a representative central estimate for engineering analyses. The influence of imposed suction (h0) was also examined; however, no systematic dependence on the applied values was identified. Comparison with published data shows that the results fall within the range reported for compacted and filtered tailings, while reinforcing that hydraulic conductivity cannot be inferred from void ratio alone. The study highlights the importance of direct field measurements for supporting seepage analyses, transient flow modelling, water balance assessments, and hydraulic characterization of filtered tailings stacks.