This case study investigates the application of distributed fiber optic sensors for strain monitoring in small-diameter bored piles (D = 0.15 m, L = 3 m) subjected to compressive and tensile loading. A full-scale load test was conducted at the UFPR facilities where, simultaneously, one test pile was loaded in compression and two reaction piles were subjected to tension. The subsurface profile was characterized through a Standard Penetration Test, revealing stiff sandy clay and clayey silt layers. Instrumentation included electrical strain gauges installed at three depths and distributed fiber-optic sensing both in test and reaction piles. The optical fiber of the test pile was pre-tensioned to ensure adequate strain response under compression. Load-displacement curves indicated small settlements and primarily elastic behavior for all piles. For the test pile, comparisons of load transfer profiles derived from strain gauges and fiber optic measurements revealed good agreement at intermediate depths but discrepancies near the pile head and tip, largely attributed to temperature sensitivity and fiber bending effects. Reaction piles showed improved consistency between measurement systems, though early loading stages exhibited spurious negative skin friction in fiber-based results. Overall, the findings confirm the feasibility of using distributed fiber optic sensing in small-diameter bored piles, while highlighting installation-related factors that significantly influence measurement quality.